Injection Molding Technician

SUMMARY
Works on assignments that are complex in nature where considerable judgment and initiative are required in resolving problems and making recommendations. Responsibilities are across all Workcell diagnostic/troubleshooting from with ICT or FVT perspective.

ESSENTIAL DUTIES AND RESPONSIBILITIES include the following. Other duties may be assigned.
·         Analyze daily process yield reports that will include, but not limited to the following: operator errors, defective product, test equipment/test defects, RMA product defects, and spear corrective actions.
·         Increase production yields by understanding and reducing operator errors and driving manufacturing and test engineering defects back to the appropriate department.
·         Assist Test Engineer in developing preventative maintenance program and assure compliance to reduce downtime and increase process yields throughout the process.
·         Analyze downtime sheets recording downtime of a station to set guidelines for preventative maintenance scheduling.
·         Ensure all process bibles are maintained properly.
·         Review all 5x5’s to ensure that they were performed and adhered to.
·         Perform walkthroughs, inspections, product evaluation and testing as needed.
·         Conduct NPI test evaluations.
·         Proactively prevent test escapes.
·         Ensure product testing completeness and reliability.
·         Update and generate documentation as required.
·         Assist Project Test Engineer with test process review.
·         Evaluates test probes.
·         Set-up equipment to perform any required programming and verification test following established procedures for the specified operations to be performed.
·         Ensure quality (work meets or exceeds Jabil Workmanship Standards) and improve efficiency through the use of the SPC system when available.
·         Operates automated electronic test equipment on manufactured circuit board assemblies and subassemblies.
·         Responsible for maintaining a continuous flow of the manufacturing line and meeting production goals while performing the assigned test duties.
·         Correctly label and stamp boards, and fill out tags.
·         Advise supervisor of any recurring test failure so that prompt corrective action may be taken.
·         Ensure assemblies are properly handled and marked.
·         Ensure daily logs and move/production tickets are accurately maintained.
·         Follows simple, standardized and routine written directions for assigned test operations.
·         Adhere to all safety and health rules and regulations
·         Comply and follow all procedures within the company security policy

MINIMUM REQUIREMENTS
AS degree, Technical School Certification, or equivalent and 5 to 10 years experience, or equivalent combination of work experience and education. Knowledge and understanding of all test engineering department’s procedures pertaining to the individual’s job.