A technical degree in radio engineering, radiophysics, electronics, or telecommunications is required.
At least 4 years of experience developing, assembling, debugging, and testing RF/microwave electronic devices is required.
Confident hands-on soldering and assembly skills with SMD/BGA components, chips, RF connectors, and cable assemblies are required.
Experience with physical assembly, prototyping, breadboarding, and tuning RF blocks and modules is required.
Ability to use VNAs, spectrum analyzers, oscilloscopes, signal generators, and power meters is required.
Ability to measure and interpret path parameters, including S-parameters, gain, noise figure, P1dB, VSWR, and phase noise, is required.
Familiarity with the RF component market and the ability to find component alternatives, read datasheets, and independently build a bill of materials are required.
Working-communication fluency in English is required.
Responsibilities
Participate in the full development cycle of RF devices and modules, from idea to prototype.
Assemble, solder, and tune experimental radio-electronic units.
Run laboratory testing, take measurements, and tune RF paths to specification.
Source, select, and procure RF components, connectors, and materials.
Work closely with PCB designers and firmware engineers throughout the build.
Location: Warsaw, on-site Employment: Full-time
Industry: Miltech / Defense
Our client is looking for a hands-on engineer to own the physical build side of their radio-electronic devices - from prototype to working hardware. This is not a schematic-only role: you'll be at the bench soldering, assembling, and tuning RF modules yourself.
About the Role
You'll take RF/microwave devices and modules through the full development cycle — from concept to working prototype. That means building test setups, soldering and assembling boards, running lab measurements, tuning RF paths, and sourcing the components to make it all happen. You'll work closely with PCB designers and firmware engineers, but the hands-on hardware work is yours.
What You'll Do
Participate in the full development cycle of RF devices and modules - from idea to prototype
Assemble, solder, and tune experimental radio-electronic units
Run lab testing, take measurements, and tune RF paths to spec
Source, select, and procure RF components, connectors, and materials
Work closely with PCB designers and firmware engineers throughout the build
What We're Looking For
Technical degree in radio engineering, radiophysics, electronics, or telecommunications
4 + years developing, assembling, debugging, and testing RF/microwave electronic devices