N

Northwood Space

Manufactures and deploys satellite ground stations

Power Electronics Engineer

Power Systems EngineeringUpdated on Nov 7
Full-time$104k - $153k /yrIn-person

About the Job

Requirements

  • A bachelor's degree in electrical engineering or a related engineering discipline is required.
  • Three to five or more years of power electronics hardware design experience are required.
  • Hands-on experience designing switched-mode power converters such as buck, boost, flyback, or LLC converters at hundreds of watts or more is required.
  • Experience taking power hardware from schematic and layout through bring-up, characterization, and laboratory debugging is required.
  • Proficiency with circuit simulation tools such as LTspice, PLECS, or SIMetrix is required.
  • Comfort using power electronics test equipment, including oscilloscopes with differential and current probes, electronic loads, and power analyzers, is required.

Responsibilities

  • Design power electronics for Prism, including AC-DC and DC-DC conversion, power distribution, and supplies that drive high-power RF amplifiers.
  • Define Prism's power architecture and drive system trades across efficiency, thermal load, reliability, cost, and deployment speed.
  • Design load switching, sequencing, and power-path protection schemes, including fault detection and recovery.
  • Perform schematic capture, oversee PCB layout, and bring up power hardware.
  • Build circuit and system models to analyze and verify power-system performance, including stability, transient response, and efficiency.
  • Define interfaces between the power system and Prism's RF, digital, and motion-control loads.
  • Qualify designs through environmental and EMI/EMC testing.

Desired Qualifications

  • A master's degree or PhD in electrical engineering focused on power electronics is preferred.
  • Kilowatt-class AC-DC and isolated DC-DC converter design, including power-factor correction, is preferred.
  • Drain supply and bias design for GaN RF power amplifiers, including sequencing and low-ripple regulation, is preferred.
  • Protection-circuit design, including hot-swap, inrush limiting, overcurrent, and reverse-polarity protection, is preferred.
  • Input-filter design and control-loop compensation for converter stability are preferred.
  • Surge, lightning, and transient protection for grid-connected outdoor equipment are preferred.
  • Magnetics design and wide-bandgap (GaN, SiC) power-stage design are preferred.
  • Motor-drive power electronics for antenna positioners or motion-control systems are preferred.
  • Thermal design and EMI/EMC mitigation for high-density power hardware are preferred.
  • Design for manufacturing, production-test development, and reliability qualification are preferred.

About the Company

Northwood Space

Manufactures and deploys satellite ground stations

Northwood Space builds and runs a global network of satellite ground stations that provide data connectivity as a service from Earth to space. Its Portal system is a production-ready, fully digital flat-panel phased-array antenna that electronically steers and can connect to multiple satellites at once, deploying in days and working with LEO, MEO, and GEO satellites. The company differentiates itself by scalable manufacturing, a globally distributed ground-station network, and a ground-segment-as-a-service model led by a team with space hardware and software experience. Its goal is to create worldwide coverage by adding about two operational sites each month across six continents so satellite operators can access reliable Earth-space connectivity at scale.

Company size
51-200
Company stage
Series C
Total funding
$511.3M
Headquarters
Torrance, CA
Founded
2022

Recently Posted Jobs

Explore more opportunities at Northwood Space

See more jobs